Wear behavior of Al-Al3Ti composite manufactured by a centrifugal method
- 1 December 1999
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 30 (12) , 3253-3261
- https://doi.org/10.1007/s11661-999-0235-1
Abstract
No abstract availableKeywords
This publication has 22 references indexed in Scilit:
- Control of composition gradient in a metal-ceramic functionally graded material manufactured by the centrifugal methodComposites Part A: Applied Science and Manufacturing, 1998
- Amorphization and precipitation within the amorphous layer induced by dry sliding wear of an composite materialActa Materialia, 1996
- Amorphous and alloy film formation in sliding of silver on copperWear, 1995
- Behavior of surface layers during the reciprocating wear of SiC-Al/Si metal matrix compositesScripta Metallurgica et Materialia, 1995
- Measurement of fiber orientation in short-fiber compositesActa Metallurgica et Materialia, 1994
- The formation of metastable Ti–Al solid solutions by mechanical alloying and ball millingJournal of Materials Research, 1993
- Preparation of AlxTi100-x Alloys by Mechanical Alloying.Journal of the Japan Society of Powder and Powder Metallurgy, 1993
- Wear rate transitions in cast aluminum-silicon alloys reinforced with SiC particlesScripta Metallurgica et Materialia, 1992
- Metastable phases in the Al3X (X = Ti, Zr, and Hf) intermetallic systemScripta Metallurgica et Materialia, 1991
- Nanocrystalline titanium-magnesium alloys through mechanical alloyingJournal of Materials Research, 1990