$D$-Band Total Power Radiometer Performance Optimization in an SiGe HBT Technology
- 10 February 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 60 (3) , 813-826
- https://doi.org/10.1109/tmtt.2012.2184132
Abstract
A D-band SiGe HBT total power radiometer is reported with a peak responsivity of 28 MV/W, a noise equivalent power (NEP) of 14-18 fW/Hz1/2, and a temperature resolution better than 0.35 K for an integration time of 3.125 ms. The 1/f noise corner of the radiometer is lower than 200 Hz. Fabricated in a developmental technology with 270-GHz fT and 330-GHz/max, it includes a five-stage low-noise amplifier (LNA) with 4-7-GHz bandwidth and over 35 dB of gain centered at 165 GHz, along with a square-law detector with an NEP below 6 pW/Hz1/2 up to 170 GHz. An average system noise temperature of 1645 K is obtained using the Y-factor method and a noise bandwidth of 10 GHz calculated from the measured S21(f) characteristics of the radiometer. The reduced 1/f noise corner frequency in the presence of the amplifier, compared to that of the detector, appears to indicate that, unlike in III-V radiometers, LNA gain fluctuations are not a problem in SiGe HBT radiometers. The circuit consumes 95 mW and occupies 765 × 490 μm2. Wafer mapping of the radiometer sensitivity and of the amplifier gain was performed across different process splits. The mapping results demonstrate that the radiometer can be employed as a relatively simple and area-efficient transistor noise-measure monitor, useful in SiGe HBT vertical profile optimization.Keywords
This publication has 14 references indexed in Scilit:
- Characterization of the Noise Parameters of SiGe HBTs in the 70–170-GHz RangeIEEE Transactions on Microwave Theory and Techniques, 2011
- Millimeter-Wave Wafer-Scale Silicon BiCMOS Power Amplifiers Using Free-Space Power CombiningIEEE Transactions on Microwave Theory and Techniques, 2011
- A 160-GHz low-noise downconversion receiver front-end in a SiGe HBT technologyInternational Journal of Microwave and Wireless Technologies, 2011
- A Passive W-Band Imaging Receiver in 65-nm Bulk CMOSIEEE Journal of Solid-State Circuits, 2010
- A 120–145 GHz Heterodyne Receiver Chipset Utilizing the 140 GHz Atmospheric Window for Passive Millimeter-Wave Imaging ApplicationsIEEE Journal of Solid-State Circuits, 2010
- Design and Characterization of $W$-Band SiGe RFICs for Passive Millimeter-Wave ImagingIEEE Transactions on Microwave Theory and Techniques, 2010
- A 94-GHz passive imaging receiver using a balanced LNA with embedded Dicke switchPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2010
- Integrated receivers up to 220 GHz utilizing GaAs-mHEMT technologyPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2009
- A 140-GHz double-sideband transceiver with amplitude and frequency modulation operating over a few metersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2009
- 0.13 $\mu$m SiGe BiCMOS Technology Fully Dedicated to mm-Wave ApplicationsIEEE Journal of Solid-State Circuits, 2009