Influence of Structural and Adsorbed Si on the Transformation of Synthetic Ferrihydrite
- 1 June 1989
- journal article
- Published by Cambridge University Press (CUP) in Clays and Clay Minerals
- Vol. 37 (3) , 273-279
- https://doi.org/10.1346/ccmn.1989.0370312
Abstract
The transformation of ferrihydrite to goethite and/or hematite, as influenced by the presence of co-precipitated Si, was investigated by infrared spectroscopy (IR), X-ray powder diffraction (XRD), and transmission electron microscopy (TEM). Ferrihydrite samples having Si/Fe molar ratios ranging from 0 to 1 were synthesized by reacting Fe2(SO4)3 with NaOH to an equilibrium pH of 8.2 in the presence of Na2SiO3. The XRD pattern of the Si-free sample contained five distinct but weak peaks, whereas the patterns of ferrihydrite samples containing Si had only two broad bands. With an increase of the Si/Fe molar ratio from 0.10 to 1.0, the 2.54-Å XRD peak shifted to 2.97 Å, and broad IR bands were observed at 990 cm−1 (Si-O stretching region) and 450 cm−1 (silicate bending region). The intensities of both IR bands increased with increasing Si/Fe molar ratio.Ferrihydrite samples were incubated at room temperature in sodium acetate/acetic acid buffer solutions at pH 3, 5, 7, and 10 and in CaCO3 suspension at pH 8.3 for 10 months. Additional samples were incubated at pH 12.5 at 24°, 40°, 60°, and 91°C for 36 hr. Room-temperature incubation of ferrihydrite samples having Si/Fe molar ratios ≥0.1 at pH 3 for one week resulted in the dissolution of Fe and the precipitation of silica gel. Ferrihydrite samples having Si/Fe molar ratios ≤0.05 transformed to poorly crystalline goethite during room-temperature incubation at pH 5. The rate of transformation and the degree of crystallinity of the product were inversely related to Si/Fe molar ratio, and, with heat treatment, were also dependent on incubation temperature. Siliceous ferrihydrite samples having Si/Fe molar ratios ≥0.10 did not transform to phases having greater crystallinity during incubation at either room temperature in buffered solutions at pH ≥7 for as long as 10 months or at pH 12.5 at 91°C for 36 hr. The XRD peak at 2.97 Å did not shift significantly during incubation procedures, providing evidence that the structure of the high-Si ferrihydrite was not significantly altered.Keywords
This publication has 16 references indexed in Scilit:
- Mineralogy and reactivity of amorphous Si-FerrihydriteSolid State Ionics, 1988
- Synthetic ferrihydrite as a potential iron amendment in calcareous soilsJournal of Plant Nutrition, 1986
- Iron oxide mineralogy of placic horizonsEuropean Journal of Soil Science, 1984
- Hydrous iron oxide minerals with short range order deposited in a spring/stream system, Tongariro National Park, New ZealandSoil Research, 1982
- Natural ferrihydrites in surface deposits from Finland and their association with silicaGeochimica et Cosmochimica Acta, 1981
- The Influence of [Fe(II)], [Si], and pH on the formation of lepidocrocite and ferrihydrite during oxidation of aqueous FeCl2 solutionsClay Minerals, 1976
- Natural “amorphous” ferric hydroxideGeoderma, 1973
- ANION ADSORPTION BY GOETHITE AND GIBBSITEEuropean Journal of Soil Science, 1972
- HETEROGENEITY IN SILICON‐IRON MIXED HYDROXIDESEuropean Journal of Soil Science, 1969
- Über die Hydrolyse von Eisen(III)‐perchlorat‐LösungenHelvetica Chimica Acta, 1962