EFFECTS OF HEATING RATE AND PARTICLE SIZE ON THE PRODUCTS YIELDS FROM RAPID PYROLYSIS OF BEECH-WOOD
- 1 April 1996
- journal article
- research article
- Published by Taylor & Francis in Fuel Science and Technology International
- Vol. 14 (4) , 479-502
- https://doi.org/10.1080/08843759608947593
Abstract
Effects of pyrolysis temperature (300–1000 °C), heating rates (100, 500, 1000, and 10,000 °C/s), and particle sizes (53–63,104–120,177–270, and 270–500 urn) on the yields and formation rates of tar, light oils, total gases, and char from pyrolysis of beech-wood under 1 atm helium pressure were studied. Wood particles were pyrolyzed in strips of stainless steel wire mesh in a captive sample apparatus; and yields of products were measured in weight percent of original wood as a function of temperature for different heating rates and particle sizes. The overall weight loss achieved from pyrolysis of this wood was about 90%. The total yields of tar and light oils from pyrolysis of this wood accounted for up to 80% of the original wood above 400 °C. Due to the post-pyrolysis reactions of tar and light oils, the tar and light oils yields go through a maximum with pyrolysis temperature for all particle sizes and most heating rates studied here. As particle size increases from 53–63 μm to 270–500 μm the maximum tar yield decreases from 53% to about 38%. The maximum tar yield also decreases with increasing the heating rate from 70% at 100 °C/s to 48% at 10,000 °C/s heating rate. Theses results indicate that as the intra-panicle post-pyrolysis cracking reactions of tar increases at higher heating rates and with larger particles the tar yield decreases. Tar was also analyzed with GPC for the effects of above pyrolysis parameters on the tar molecular weight. The tar average molecular weight. remains relatively constant (Mw = 300 amu, Mn = 155 amu, and Mz = 483 amu) under helium atmosphere with pyrolysis temperature at 1000 °C/s heating rate and with 53/63 u m particle size. The average molecular weight of tar does not significantly varies with heaung rate, but it decreases as the particle size increases.Keywords
This publication has 8 references indexed in Scilit:
- An experimental and modeling study of pressure effects on tar release by rapid pyrolysis of cellulose sheets in a screen heaterCombustion and Flame, 1993
- Intraparticle nonisothermalities in coal pyrolysisEnergy & Fuels, 1988
- Product compositions and kinetics in the rapid pyrolysis of milled wood ligninIndustrial & Engineering Chemistry Process Design and Development, 1985
- Product compositions and kinetics in the rapid pyrolysis of sweet gum hardwoodIndustrial & Engineering Chemistry Process Design and Development, 1985
- Product compositions and kinetics for rapid pyrolysis of celluloseIndustrial & Engineering Chemistry Process Design and Development, 1982
- Effects of calcium minerals on the rapid pyrolysis of a bituminous coalIndustrial & Engineering Chemistry Process Design and Development, 1981
- Thermochemical Gasification of Woody BiomassPublished by American Chemical Society (ACS) ,1981
- A review of kinetics data for the pyrolysis of wood and related substancesCombustion and Flame, 1970