Effects of Glass Contamination and Electrode Curvature on Electrical Breakdown in Vacuum
- 1 February 1963
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 34 (2) , 319-322
- https://doi.org/10.1063/1.1702606
Abstract
It has recently been found that particles of contamination reside on surfaces inside vacuum systems as a result of thermal decomposition of glass. These particles contain at least Na, K, and B as well as traces of Al and Si. They may well have been important in many clean surface experiments. Our investigation has shown that these particles have a strong influence in reducing the breakdown voltage in vacuum. Breakdown voltages for Al, Cu, and stainless steel electrodes with radii of curvature of 12.7, 25.4, 50.8, and 101.6 mm were determined under clean and contaminated conditions at 10−5 Torr. It was found that under clean conditions the electrodes of smaller radii of curvature have higher breakdown voltages than the more nearly plane electrodes.This publication has 9 references indexed in Scilit:
- Cranberg Hypothesis of Vacuum Breakdown as Applied to Impulse VoltagesJournal of Applied Physics, 1962
- Particulate contamination from glassVacuum, 1962
- New Derivation of the Vacuum Breakdown Equation Relating Breakdown Voltage and Electrode SeparationJournal of Applied Physics, 1961
- The electrical breakdown in vacuumApplied Scientific Research, Section B, 1961
- Vacuum as an insulatorVacuum, 1960
- pLayers on Vacuum Heated SiliconJournal of Applied Physics, 1960
- Glass, a Disturbing Factor in Physical Electronics MeasurementsJournal of Applied Physics, 1959
- The Initiation of Electrical Breakdown in VacuumJournal of Applied Physics, 1952
- The Effect of Temperature, Degree of Thoriation and Breakdown on Field Currents from Tungsten and Thoriated TungstenPhysical Review B, 1936