Influence of grain refinement and modification on microstructure and mechanical properties of Al–7Si and Al–7Si–2.5Cu cast alloys
- 31 March 2008
- journal article
- Published by Elsevier in Materials Characterization
- Vol. 59 (3) , 283-289
- https://doi.org/10.1016/j.matchar.2007.01.011
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- Low temperature superplasticity of a fine-grained ZK60 magnesium alloy processed by equal-channel-angular extrusionScripta Materialia, 2002
- Orientation imaging microscopy of ultrafine-grained nickelPublished by Elsevier ,2002
- Effect of composition and processing route on the wear behaviour of Al–Si alloysScripta Materialia, 2002
- Billet temperature rise during equal-channel angular pressingScripta Materialia, 2002
- Achieving superplasticity in a Cu–40%Zn alloy through severe plastic deformationScripta Materialia, 2001
- Rotary-die equal-channel angular pressing of an Al – 7 mass% Si – 0.35 mass% Mg alloyScripta Materialia, 2001
- Influence of rolling on the superplastic behavior of an Al-Mg-Sc alloy after ECAPScripta Materialia, 2001
- Development of an efficient grain refiner for Al–7Si alloy and its modification with strontiumPublished by Elsevier ,2000
- Principle of equal-channel angular pressing for the processing of ultra-fine grained materialsPublished by Elsevier ,1999
- Low temperature superplasticity in an AZ91 magnesium alloy processed by ECAEScripta Materialia, 1997