A pressure-balanced electrostatically-actuated microvalve
- 1 January 1990
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 44, 123-127
- https://doi.org/10.1109/solsen.1990.109835
Abstract
A new microvalve structure designed to enhance the limited actuation forces available in microfabricated devices by using a pressure-balancing scheme is reported. The concept is to allow the fluid to provide a balancing force on the moving part of the device, thereby reducing the force required to open the valve. Various methods can be used to actuate the valve, but electrostatic actuation is chosen since it is readily integrated with the valve fabrication sequence. The process for implementing the valve concept uses multiple wafer bonding steps (three in the present prototype) and has yielded valves which have been successfully actuated in air using voltages below 350 V.<>Keywords
This publication has 6 references indexed in Scilit:
- A constant flow-rate microvalve actuator based on silicon and micromachining technologyPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- A micro chemical analyzing system integrated on a silicon waferPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Micromachined silicon microvalvePublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- A piezoelectric micropump based on micromachining of siliconSensors and Actuators, 1988
- Warpage of Silicon WafersJournal of the Electrochemical Society, 1980
- A gas chromatographic air analyzer fabricated on a silicon waferIEEE Transactions on Electron Devices, 1979