Survey of Bisphenol A diglycidyl ether (BADGE) in canned foods
- 1 October 1998
- journal article
- research article
- Published by Taylor & Francis in Food Additives & Contaminants
- Vol. 15 (7) , 818-830
- https://doi.org/10.1080/02652039809374716
Abstract
2,2‐Bis (4‐hydroxyphenyl) propane bis (2,3‐epoxypropyl) ether (BADGE) is used in the manufacture of lacquers for coating the inside of food and beverage cans. In June 1996 the EC Scientific Committee for Food temporarily increased the specific migration limit applying to BADGE to 1 mg/kg pending consideration of additional toxicological data. In order to find out if there is migration of BADGE from can coatings into foods, a ‘worst case’ sampling exercise has been conducted to survey those canned foods where the propensity for migration of BADGE was judged to be highest. The foods surveyed include canned fish in oil, meat and milk and, altogether, BADGE was determined in 181 retail samples. Analysis for BADGE was conducted, in duplicate, by HPLC with fluorescence detection with confirmation of BADGE identity by GC/MS analysis using selected ion monitoring. BADGE was found at levels exceeding 1 mg/kg in seven of the 15 canned anchovy samples and five of the 22 sardine samples purchased during the period September 1995‐July 1996. Infrared analysis of the can coatings provided strong evidence that the higher BADGE levels found were associated with use of PVC organosol lacquers, although in some cases cans coated with organosols gave low BADGE results. For canned sardine samples found to contain greater than 0.5 mg/ kg BADGE in the total contents, a replicate can was opened and separate analyses performed on the drained fish and the oil. The results clearly showed that BADGE concentrations in the oil were about 20 times higher than in the drained fish. Further samples of canned sardines and anchovies were purchased in June/July 1997 and, in all cases, BADGE levels were found to be below 1 mg/kg. In the other retail canned foods, BADGE was not detectable (DL = 0.02 mg/kg) or detected at concentrations well below the temporary SML of 1 mg/kg.Keywords
This publication has 10 references indexed in Scilit:
- Detection of residues of the epoxy adhesive component bisphenol A diglycidyl ether (BADGE) in microwave susceptors and its migration into foodFood Additives & Contaminants, 1995
- Harmonized guidelines for internal quality control in analytical chemistry laboratories (Technical Report)Pure and Applied Chemistry, 1995
- Determination of Bisphenols A and F in Noncured Epoxy Resins by RP-HPLC--Fluorescence TechniquesJournal of Chromatographic Science, 1993
- Overall migration and specific migration of bisphenol A diglycidyl ether monomer andm‐xylylenediamine hardener from an optimized epoxy‐amine formulation into water‐based food simulantsFood Additives & Contaminants, 1993
- Kinetics of the hydrolysis of bisphenol A diglycidyl ether (BADGE) in water-based food simulantsAnalytical and Bioanalytical Chemistry, 1993
- Identification of RP-HPLC peaks of bisphenol F and of bisphenol F diglycidyl ether and its hydrolysis products by thermospray mass spectrometry and gas chromatography/mass spectrometryChromatographia, 1992
- Kinetics of the hydrolysis of bisphenol F diglycidyl ether in water-based food simulants. Comparison with bisphenol A diglycidyl etherJournal of Agricultural and Food Chemistry, 1992
- RP-HPLC--TSP--MS of Epoxy Resins Bisphenol A Diglycidyl Ether TypeJournal of Chromatographic Science, 1992
- Quality control of cured epoxy resins: Determination of residual free monomers (m-xylylenediamine and bisphenol A diglycidyl ether) in the finished productJournal of Chromatography A, 1991
- Evaluation of analytical methods used for regulation of foods and drugsAnalytical Chemistry, 1982