Gas-Temperature-Controlled (GTC) CVD of Aluminum and Aluminum-Silicon Alloy Film for VLSI Processing
- 1 November 1988
- journal article
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 27 (11A) , L2134
- https://doi.org/10.1143/jjap.27.l2134
Abstract
In order to investigate the feasibility of CVD metallization for IC manufacturing processes, Al and Al-Si film depositions on silicon (100) wafers were studied using a precursor gas of triisobutylaluminum with and without disilane. A new mechanism for the gas temperature controller (GTC) was provided in the process chamber so as to activate the gas thermally just prior to its arrival at a heated substrate. The typical deposition rate was 700 nm/min. Without post-annealing, an alloy of Al-0.4%Si was obtained. Specific resistivity was 3.0 µΩ·cm, and specularity was about 60% at 550 nm for the GTC-CVD films of 1 µm thickness.Keywords
This publication has 8 references indexed in Scilit:
- Low Pressure Chemical Vapor Deposition of Tungsten and Aluminum for VLSI ApplicationsJournal of the Electrochemical Society, 1987
- Properties of LPCVD Aluminum Films Produced by Disproportionation of Aluminum MonochlorideJournal of the Electrochemical Society, 1985
- Characterization of LPCVD Aluminum for VLSI ProcessingJournal of the Electrochemical Society, 1984
- Aluminum films prepared by metal-organic low pressure chemical vapor depositionThin Solid Films, 1984
- Photodeposition of aluminum oxide and aluminum thin filmsApplied Physics Letters, 1983
- Vapor Phase Deposition of Aluminum Film on Quartz SubstrateJournal of the Electrochemical Society, 1983
- Characterization and properties of controlled nucleation thermochemical deposition (CNTD)-silicon carbideJournal of Materials Science, 1980
- Kinetics of the intramolecular four-center elimination of isobutylene from triisobutylaluminum in the gas phaseJournal of the American Chemical Society, 1969