Design and Fabrication of an Industrial-Grade Instrument to Measure Texture and Predict Drawability in Sheet Metal
- 1 January 1991
- book chapter
- Published by Springer Nature
- p. 2053-2060
- https://doi.org/10.1007/978-1-4615-3742-7_119
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Influence of anisotropy on the dispersion characteristics of guided ultrasonic plate modesThe Journal of the Acoustical Society of America, 1990
- Application of a Fourier Transform-Phase-Slope Technique to the Design of an Instrument for the Ultrasonic Measurement of Texture and StressPublished by Springer Nature ,1990
- Lankford Coefficient Evaluation in Steel Sheets by an Ultrasonic MethodPublished by Springer Nature ,1989
- Nondestructive Analysis of the Deep-drawing Behaviour of Rolling Sheets with Ultrasonic TechniquesPublished by Springer Nature ,1989
- Relative anisotropies of plane waves and guided modes in thin orthorhombic plates: Implication for texture characterizationUltrasonics, 1987
- Electromagnetic, Noncontact TransducersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1973
- Elastic and plastic anisotropy in sheets of cubic metalsMetallurgical Transactions, 1972
- Elastic wave velocities in various alloy stripsMetallurgical Transactions, 1971
- The use of young’s modulus for predicting the plastic-strain ratio of low-carbon steel sheetsMetallurgical Transactions, 1970
- Inversion of Pole Figures for Materials Having Cubic Crystal SymmetryJournal of Applied Physics, 1966