Graft force-setting technique in reconstruction of the anterior cruciate ligament
- 1 January 1990
- journal article
- research article
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 18 (1) , 12-19
- https://doi.org/10.1177/036354659001800102
Abstract
The objective of this work was to present a method for controlling the mechanical state of the knee during graft fixation in an ACL reconstruction; that is, adjusting the unloaded length of the graft at the time of fixation so that the force-carrying characteristics of the graft match that of the intact ACL, when the normal and recon structed knees are subjected to the same external load. To demonstrate the new method, an experimental knee testing system was used to measure ligament and graft forces with buckle transducers, as external loads were applied to five fresh knee specimens with a pneumatic load apparatus. ACL and collateral ligament force data were collected as anteriorly directed loads of 90 N (20 pounds) were applied at 0°, 30°, 60°, and 90° of flexion in the normal intact knee and the same knee following ACL excision. A composite graft was prepared, con sisting of distally based semitendinosus and gracilis autogenous tissue augmented with the Kennedy Liga ment Augmentation Device. Femoral fixation was ob tained using a fixation plug that was inserted through the lateral femoral condyle. With a 90 N anterior tibial load applied at 30° of flexion and a single buckle transducer measuring the total composite graft force, the graft length was varied using the fixation plug until the force matched that seen by the intact ACL under the same loading condition. The graft was then clamped in the fixation plug and the anterior load sequence at the four flexion angles was applied to this reconstructed knee state. Ligament and graft forces were measured and compared to the normal intact knee and cut ACL force data. The proposed force-setting method of ACL reconstruction resulted in graft forces that were closer to normal than when using current reconstruction meth ods based on isometry and pretension, and allowed better reproducibility of total graft forces among a series of knees.This publication has 33 references indexed in Scilit:
- Knee Joint Motion and Ligament Forces Before and After ACL ReconstructionJournal of Biomechanical Engineering, 1989
- Load sharing and graft forces in anterior cruciate ligament reconstructions with the Ligament Augmentation DeviceThe American Journal of Sports Medicine, 1989
- On the Interpretation of Our Anterior Cruciate Ligament DataPublished by Wolters Kluwer Health ,1985
- An in vivo strain gage study of elongation of the anterior cruciate ligamentThe American Journal of Sports Medicine, 1985
- The biomechanics of anterior cruciate ligament rehabilitation and reconstructionThe American Journal of Sports Medicine, 1984
- Vascularized Patellar Tendon Graft with Rigid Internal Fixation for Anterior Cruciate Ligament InsufficiencyClinical Orthopaedics and Related Research, 1983
- Anatomy of the Anterior Cruciate LigamentClinical Orthopaedics and Related Research, 1983
- Presidential addressThe American Journal of Sports Medicine, 1980
- The Cruciate Ligaments of the Knee JointClinical Orthopaedics and Related Research, 1975
- Reconstruction of the Anterior Cruciate LigamentJournal of Bone and Joint Surgery, 1963