Injection molding: The effect of fill time on properties
- 1 April 1986
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 26 (7) , 488-498
- https://doi.org/10.1002/pen.760260707
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Crystalline and amorphous orientations in injection molded polyethylenePolymer Engineering & Science, 1980
- Some relationships between injection molding conditions and the characteristics of vitrified molded partsPolymer Engineering & Science, 1979
- Cavity temperature—an important parameter in the injection molding processPolymer Engineering & Science, 1979
- Orientation development and relaxation in injection molding of amorphous polymersPolymer Engineering & Science, 1978
- Experimental characterization of the alignment of short fibers during flowPolymer Engineering & Science, 1977
- Strength and Elastic Modulus of a Randomly-Distributed Short Fiber CompositeJournal of Composite Materials, 1975
- Polymer‐glass separation in the spiral mold testPolymer Engineering & Science, 1974
- A special mold and tracer technique for studying shear and extensional flows in a mold cavity during injection moldingPolymer Engineering & Science, 1974
- Flow visualization for injection molding of polyethylene and polystyrene meltsPolymer Engineering & Science, 1974
- Studies on crystallization of high polymers by differential thermal analysisJournal of Polymer Science Part A: General Papers, 1963