Diffusion of Degradation Products in Ceramic Moldings during Pyrolysis: Effect of Geometry
- 1 March 1996
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 79 (3) , 749-755
- https://doi.org/10.1111/j.1151-2916.1996.tb07938.x
Abstract
No abstract availableKeywords
This publication has 16 references indexed in Scilit:
- Development of temperature-heating rate diagrams for the pyrolytic removal of binder used for powder injection mouldingJournal of Materials Science, 1992
- Pressure buildup and internal stresses during binder burnout: Numerical analysisAIChE Journal, 1991
- On the removal of organic vehicle from moulded ceramic bodiesProceedings of the Royal Society of London. Series A: Mathematical and Physical Sciences, 1991
- Interfacial factors affecting the incidence of defects in ceramic mouldingsJournal of Materials Science, 1991
- Simultaneous momentum, heat and mass transfer with chemical reaction in a disordered porous medium: application to binder removal from a ceramic green bodyChemical Engineering Science, 1990
- Liquid‐Phase Transport During Removal of Organic Binders in Injection‐Molded CeramicsJournal of the American Ceramic Society, 1990
- Theoretical Models for Binder BurnoutJournal of the American Ceramic Society, 1990
- A method for selecting organic materials for ceramic injection mouldingCeramics International, 1990
- Review: Fabrication of engineering ceramics by injection moulding. I. Materials selectionInternational Journal of High Technology Ceramics, 1986
- Review: Fabrication of engineering ceramics by injection moulding. II. TechniquesInternational Journal of High Technology Ceramics, 1986