CATALYTIC OXIDATION OF CO ON CuO/Al2O3. II. MEASUREMENT AND DESCRIPTION OF HYSTERESIS AND OSCILLATIONS IN A LABORATORY CATALYTIC RECYCLE REACTOR†
- 1 January 1973
- journal article
- research article
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 1 (2) , 95-102
- https://doi.org/10.1080/00986447308960418
Abstract
Under certain experimental conditions sustained oscillations of catalyst bed temperature and CO concentration in the reactor described in Part I were observed. "Ignition-extinction" phenomena with associated hysteresis were also measured in the regions of experimental conditions where observed reaction rate was substantially effected by heat and mass transport limitations. The application of a two-phase model for explanation and description of oscillations and ignition-extinction phenomena is discussed in detailKeywords
This publication has 10 references indexed in Scilit:
- Zur Kenntnis des Zweiphasenmodells des katalytischen ReaktorsChemie Ingenieur Technik - CIT, 1973
- Quasilinearized RegressionTechnometrics, 1971
- Modeling of chemical reactors—XVIII stability and oscillatory behaviour of the CSTRChemical Engineering Science, 1970
- Modeling of chemical reactors — XVI Steady state axial heat and mass transfer in tubular reactors An analysis of the uniqueness of solutionsChemical Engineering Science, 1970
- Catalytic Combustion of Carbon Monoxide on Copper Oxide. Effect of Carbon DioxideIndustrial & Engineering Chemistry Process Design and Development, 1969
- Stability of batch catalytic fluidized bedsAIChE Journal, 1968
- Discrimination Among Mechanistic ModelsTechnometrics, 1967
- Catalytic Combustion and Adsorption Kinetics of Carbon Monoxide on Cupric OxideIndustrial & Engineering Chemistry Process Design and Development, 1966
- The Modified Gauss-Newton Method for the Fitting of Non-Linear Regression Functions by Least SquaresTechnometrics, 1961
- CATALYTIC OXIDATION OF CARBON MONOXIDE PRESENT IN LOW CONCENTRATIONSCanadian Journal of Chemistry, 1960