AN UNDERSTANDING OF THE FLUID MOTION AND PRESSURE BUILD-UP IN A NON-ISOTHERMAL INJECTION MOLD PACKING STAGE
- 1 July 1988
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of Polymer Engineering
- Vol. 8 (3-4) , 175-202
- https://doi.org/10.1515/polyeng.1988.8.3-4.175
Abstract
No abstract availableThis publication has 12 references indexed in Scilit:
- An explanation of the discrepancy in gapwise‐density variation of injection‐molded parts between Kamal's and Greener's dataPolymer Engineering & Science, 1988
- Effect of a pressure-dependent viscosity on the packing stage in injection moldingIndustrial & Engineering Chemistry Research, 1987
- Pressure Effects on Rheological Behavior of Melt Polymers – A Discussion in Relation to Polymer ProcessingJournal of Polymer Engineering, 1986
- A structure‐oriented computer simulation of the injection molding of viscoelastic crystalline polymers part II: Model predictions and experimental resultsPolymer Engineering & Science, 1986
- Pressure build‐up during the packing stage of injection moldingPolymer Engineering & Science, 1985
- Microstructural characterization of injection‐molded articlesJournal of Applied Polymer Science, 1983
- Analysis of the packing stage in injection moldingPolymer Engineering & Science, 1981
- Distribution of some physical properties in injection‐molded thermoplastic partsPolymer Engineering & Science, 1977
- Packing and discharge in injection moldingPolymer Engineering & Science, 1974
- The injection molding of thermoplastics part II: Experimental test of the modelPolymer Engineering & Science, 1972