Optimization of polyester sheet molding compound. Part II: Theoretical modeling
- 1 August 1986
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 7 (4) , 250-260
- https://doi.org/10.1002/pc.750070408
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- An experimental study on the injection molding of thermosetting polyester resinPolymer Engineering & Science, 1984
- Chemorheology of thermosetting resins. I. The chemorheology and curing kinetics of unsaturated polyester resinJournal of Applied Polymer Science, 1983
- Chemorheology of thermosetting resins. III. Effect of low‐profile additive on the chemorheology and curing kinetics of unsaturated polyester resinJournal of Applied Polymer Science, 1983
- Chemorheology of thermosetting resins. II. Effect of particulates on the chemorheology and curing kinetics of unsaturated polyester resinJournal of Applied Polymer Science, 1983
- Curing of compression molded sheet molding compoundPolymer Engineering & Science, 1981
- Effect of temperature gradients on cure and stress gradients in thick thermoset castingsJournal of Applied Polymer Science, 1980
- Heats of reaction and kinetics of a thermoset polyesterJournal of Applied Polymer Science, 1979
- Effect of cure cycle on mechanical properties of thick section fiber‐reinforced poly/thermoset moldingsPolymer Engineering & Science, 1979
- The effect of deformation and thermoset cure on heat conduction in a chopped-fiber reinforced polyester during compression moldingInternational Journal of Heat and Mass Transfer, 1979
- Calorimetric investigation of polymerization reactions. IV. Curing reaction of polyester fumarate with styreneJournal of Polymer Science Part A-1: Polymer Chemistry, 1970