Analysis of cutting forces in peripheral and face milling operations
- 1 October 1972
- journal article
- research article
- Published by Taylor & Francis in International Journal of Production Research
- Vol. 10 (4) , 379-391
- https://doi.org/10.1080/00207547208929939
Abstract
The paper describes au analytical method for evaluating the cutting forces arising in (i) peripheral and (ii) face milling operations. A single shear plane model has been used to analyse the cutting action at. each tooth. A good correlation between the analytical force values and the corresponding values obtained experimentally has been observed.Keywords
This publication has 2 references indexed in Scilit:
- Oblique machining with a single cutting edgeInternational Journal of Machine Tool Design and Research, 1964
- Shear angle solution based on experimental shear zone and tool-chip interface stress distributionsInternational Journal of Mechanical Sciences, 1963