Oblique machining with triangular form tools — I. Theoretical investigation
- 31 December 1978
- journal article
- Published by Elsevier in International Journal of Machine Tool Design and Research
- Vol. 18 (2) , 67-80
- https://doi.org/10.1016/0020-7357(78)90010-0
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Drilling wih flat rake face and conventional twist drills—II. Experimental investigationInternational Journal of Machine Tool Design and Research, 1972
- Drilling with flat rake face and conventional twist drills—I. Theoretical investigationInternational Journal of Machine Tool Design and Research, 1972
- An investigation of zero helix peripheral up-millingInternational Journal of Machine Tool Design and Research, 1970
- Machining with double cutting edge tools—I. Symmetrical triangular cutsInternational Journal of Machine Tool Design and Research, 1967
- The geometry and specification of single point lathe toolsInternational Journal of Machine Tool Design and Research, 1965
- Oblique machining with a single cutting edgeInternational Journal of Machine Tool Design and Research, 1964
- An Analysis of the Mechanism of Orthogonal Cutting and Its Application to Discontinuous Chip FormationJournal of Engineering for Industry, 1961
- The Theory of Plasticity Applied to a Problem of MachiningJournal of Applied Mechanics, 1951
- Mechanics of the Metal Cutting Process. II. Plasticity Conditions in Orthogonal CuttingJournal of Applied Physics, 1945
- Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 ChipJournal of Applied Physics, 1945