Structure-property analysis for gel-spun, ultrahigh molecular mass polyethylene fibers
- 1 February 1996
- journal article
- research article
- Published by Taylor & Francis in Journal of Macromolecular Science, Part B
- Vol. 35 (1) , 37-87
- https://doi.org/10.1080/00222349608220375
Abstract
The structures of four gel-spun, ultrahigh molecular mass polyethylene fibers have been studied with the techniques of full-pattern x-ray diffraction, small-angle x-ray scattering, powder x-ray diffraction, solid-state 13C nuclear magnetic resonance, differential scanning calorimetry, and optical microscopy. A high molecular mass polyethylene fiber is also studied for comparison. At room temperature these fibers show mainly the common orthorhombic crystals and a small amount of monoclinic crystals in addition to an intermediate, oriented phase and the amorphous phase. The structure parameters of the orthorhombic phase change slightly with fiber processing history. The chains of the intermediate phase have largely a trans-conformation and are oriented preferentially parallel to the fiber axis, but are disordered laterally. The mobility (correlation time) of the carbon atoms of the intermediate phase is higher than that of the crystalline phase by 2 orders of magnitude, but lower than that of the amorphous phase by 3 orders of magnitude. The intermediate phase can contribute significantly to the meridional x-ray diffraction peaks 00l but not to the equatorial peaks hk0. A simple structural model is proposed to reconcile the experimental results. The domain which consists mainly of intermediate phase extends much longer in the fiber direction than the orthorhombic ones, which are more regularly interrupted. Fiber tensile strength is mainly determined by the mass fraction and orientation of the intermediate phase, approximated by the ratio of diffraction intensities 002/110. The initial modulus of the fibers depends also on the axial connection between the domains of the orthorhombic phase. Endothermic double peaks of fibers analyzed with free ends result from the melting of the orthorhombic crystals of different degree of restraint by the surrounding material. Both peaks occur above the equilibrium melting temperature of polyethylene. Unusually small x-ray long periods between 4.2 and 6.0 nm have been found for two of the fibers. Other long periods and the phase transformations of the monoclinic phase with temperature and on compression are also discussed.Keywords
This publication has 72 references indexed in Scilit:
- The morphology of gel‐spun polyethylene fibers, investigated by solid‐state 13C NMRJournal of Polymer Science Part B: Polymer Physics, 1994
- Crystal and molecular deformation in strained high‐performance polyethylene fibers studied by wide‐angle x‐ray scattering and Raman spectroscopyJournal of Polymer Science Part B: Polymer Physics, 1992
- Two-dimensional 13C n.m.r. studies of the morphology and orientational order in gel-spun ultrahigh molecular weight polyethylene fibresPolymer, 1992
- Molecular deformation of high‐modulus polyethylene fibers studied by micro‐raman spectroscopyJournal of Polymer Science Part B: Polymer Physics, 1991
- Structural Analysis of Polyethylene Fibers by Solid State High Resolution NMR; the Distribution of 13C Spin-Lattice Relaxation TimesPolymer Journal, 1990
- Phase Structural Analysis of Ultra High-Molecular Weight Polyethylene Fibers by Solid State High Resolution NMRPolymer Journal, 1990
- Direct observation of taut tie molecules in high‐strength polyethylene fibers by Raman spectroscopyJournal of Polymer Science Part B: Polymer Physics, 1989
- The use of fourier analysis of the x-ray diffraction line profile for calculating the distribution function of crystallites according to dimensions in oriented linear polyethylenePolymer Science U.S.S.R., 1984
- Structural features of highly oriented polyethylenePolymer Science U.S.S.R., 1984
- Dynamic mechanical behaviour and longitudinal crystal thickness measurements on ultra-high modulus linear polyethylene: a quantitative model for the elastic modulusPolymer, 1978