WSI interconnect issues: practical experience gained on the WASP project
- 9 December 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Abstract
The problems of external interfacing and internal interconnection for WSI (wafer scale integration) devices are considered. In particular, the WASP (WSI associative string processor) 2A device is examined in detail, and practical results are presented. Analysis of the experimental on-wafer interconnection included on WASP 2A has shown that, given simple layout precautions, a high yield can be obtained for non-defect-tolerant buses. However, it is also apparent that practical experience concerning the defect modes of these buses is important in the design of any defect tolerance strategy for yield improvement. Results from using WASP 2A have shown that defect and fault tolerance may be cost-effectively implemented at the level of the wafer interface, allowing for the recovery from defects and in-service failures, and substantially increasing the projected yield of this crucial wafer component.Keywords
This publication has 3 references indexed in Scilit:
- The WASP demonstrator programme: the engineering of a wafer-scale systemPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- WASP: a wafer-scale massively parallel processorPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- VLSI Design for Manufacturing: Yield EnhancementPublished by Springer Nature ,1990