A theoretical sensitivity analysis for full- dome formability tests: parameter study forn, m, r, and μ
- 1 August 1991
- journal article
- Published by Springer Nature in Metallurgical Transactions A
- Vol. 22 (8) , 1775-1788
- https://doi.org/10.1007/bf02646502
Abstract
No abstract availableKeywords
This publication has 27 references indexed in Scilit:
- Calculations of forming limit diagramsMetallurgical Transactions A, 1990
- Experimental investigation and finite element modeling of hemispherically stretched steel sheetMetallurgical Transactions A, 1989
- Effects of work-hardening and rate sensitivity on the sheet tensile testMetallurgical Transactions A, 1988
- Effect of stress-strain-law transients on formabilityMetallurgical Transactions A, 1986
- A comparison of correlations between press performance and dome tests results using two dome test proceduresJournal of Applied Metalworking, 1984
- Correlation of tensile properties with plane-strain, limiting dome heightJournal of Applied Metalworking, 1984
- Variables affecting dome test resultsJournal of Applied Metalworking, 1982
- Failure in thin sheets stretched over rigid punchesMetallurgical Transactions A, 1975
- Stretching limits in sheet metals: In-plane versus out-of-plane deformationMetallurgical Transactions, 1974
- A theory of the yielding and plastic flow of anisotropic metalsProceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences, 1948