The fluid mechanics and heat transfer of injection mold filling of thermoplastic materials
- 1 July 1976
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 22 (4) , 661-669
- https://doi.org/10.1002/aic.690220405
Abstract
No abstract availableKeywords
This publication has 13 references indexed in Scilit:
- The injection molding behavior of thermoplastics in thin rectangular cavitiesPolymer Engineering & Science, 1975
- Mold‐filling studies for the injection molding of thermoplastic materials. Part II: The transient flow of plastic materials in the cavities of injection‐molding diesPolymer Engineering & Science, 1975
- Fluid mechanical analysis of injection mold fillingPolymer Engineering & Science, 1975
- A special mold and tracer technique for studying shear and extensional flows in a mold cavity during injection moldingPolymer Engineering & Science, 1974
- Radial Flow of Non-Newtonian Fluids Between Parallel PlatesTransactions of the Society of Rheology, 1974
- Flow visualization for injection molding of polyethylene and polystyrene meltsPolymer Engineering & Science, 1974
- Simulation of the mold‐filling processPolymer Engineering & Science, 1974
- Hele Shaw flows with a free boundary produced by the injection of fluid into a narrow channelJournal of Fluid Mechanics, 1972
- The injection molding of thermoplastics part I: Theoretical modelPolymer Engineering & Science, 1972
- Two-dimensional sink flow of a stratified fluid contained in a ductJournal of Fluid Mechanics, 1972