Analysis of fatigue behavior of high‐density polyethylene based on dynamic viscoelastic measurements during the fatigue process
- 1 April 1981
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 26 (4) , 1085-1104
- https://doi.org/10.1002/app.1981.070260403
Abstract
The fatigue behavior of high‐density polyethylene was studied by measuring the variation in the dynamic viscoelasticity during the fatigue process. Brittle failure was observed under the conditions of small imposed strain amplitude, low ambient temperature, and large heat transfer coefficient to the surroundings. Ductile failure was observed under the conditions of large imposed strain amplitude, high ambient temperature, and small heat transfer coefficient to the surroundings. In the case of brittle failure, absolute value of dynamic complex modulus, ∣E*∣, showed maximum and phase difference, δ, did minimum on approaching the point of failure. In the case of ductile failure, ∣E*∣ decreased and δ increased monotonously from the start of the fatigue testing. The effect of environmental conditions on fatigue behavior was elucidated in terms of the heat transfer coefficient to the surroundings. As both forced convection of air and water enlarge the heat transfer coefficient, temperature rise of the specimen hardly occured and brittle failure took place preferentially. The coefficient, ϰ, was introduced to express the ratio of the actual generated heat to the hysteresis loss. With increase of the magnitude of the strain amplitude, the nonlinear viscoelastic behavior appeared and ϰ became smaller. A positive correlation between ϰ and lifetime was found. As the heat generation rate does not strongly affect lifetime, it was concluded that the hysteresis loss with low efficiency of heat generation would contribute to the fatigue failure. The relationship between average hysteresis loss and lifetime was proposed. The total hysteresis loss up to fatigue failure is constant, being independent of ambient temperature and imposed strain amplitude. The cumulative damage theory of fatigue failure was proposed based on hysteresis loss.Keywords
This publication has 17 references indexed in Scilit:
- Evaluation of fatigue lifetime and elucidation of fatigue mechanism in plasticized poly(vinyl chloride) in terms of dynamic viscoelasticityJournal of Applied Polymer Science, 1980
- Synthesis of polyesters from active diestersJournal of Polymer Science: Polymer Chemistry Edition, 1973
- Structural factors in deformation of crystalline polymersJournal of Macromolecular Science, Part B, 1973
- Rheological interpretation of heat generation associated with fatigue of polycarbonateJournal of Applied Polymer Science, 1970
- Fatigue and Cyclic Thermal Softening of ThermoplasticsJournal of Mechanical Engineering Science, 1970
- A model for polymer fatiguePolymer Engineering & Science, 1969
- Fatigue under complicated load histories. Law of cumulative damageJournal of Applied Polymer Science, 1967
- The tempeature generted during torsional oscillations of polyethylene rodsInternational Journal of Engineering Science, 1967
- Microplastic Strain Hysteresis Energy as a Criterion for Fatigue FractureJournal of Basic Engineering, 1961
- A note on the existence of a yield point in the dynamic modulus of loaded vulcanizatesJournal of Applied Polymer Science, 1960