A framework for noise‐power spectrum analysis of multidimensional images
Top Cited Papers
- 28 October 2002
- journal article
- research article
- Published by Wiley in Medical Physics
- Vol. 29 (11) , 2655-2671
- https://doi.org/10.1118/1.1513158
Abstract
A methodological framework for experimental analysis of the noise-power spectrum (NPS) of multidimensional images is presented that employs well-known properties of the n-dimensional (n D ) Fourier transform. The approach is generalized to n dimensions, reducing to familiar cases for n=1 (e.g., time series) and n=2 (e.g., projection radiography) and demonstrated experimentally for two cases in which n=3 (viz., using an active matrix flat-panel imager for x-ray fluoroscopy and cone-beam CT to form three-dimensional (3D) images in spatiotemporal and volumetric domains, respectively). The relationship between fully n D NPS analysis and various techniques for analyzing a “central slice” of the NPS is formulated in a manner that is directly applicable to measured n D data, highlights the effects of correlation, and renders issues of NPS normalization transparent. The spatiotemporal NPS of fluoroscopic images is analyzed under varying conditions of temporal correlation (image lag) to investigate the degree to which the NPS is reduced by such correlation. For first-frame image lag of ∼5–8 %, the NPS is reduced by ∼20% compared to the lag-free case. A simple model is presented that results in an approximate rule of thumb for computing the effect of image lag on NPS under conditions of spatiotemporal separability. The volumetric NPS of cone-beam CTimages is analyzed under varying conditions of spatial correlation, controlled by adjustment of the reconstruction filter. The volumetric NPS is found to be highly asymmetric, exhibiting a ramp characteristic in transverse planes (typical of filtered back-projection) and a band-limited characteristic in the longitudinal direction (resulting from low-pass characteristics of the imager). Such asymmetry could have implications regarding the detectability of structures visualized in transverse versus sagittal or coronal planes. In all cases, appreciation of the full dimensionality of the image data is essential to obtaining meaningful NPS results. The framework may be applied to NPS analysis of image data of arbitrary dimensionality provided the system satisfies conditions of NPS existence.Keywords
Funding Information
- National Institutes of Health (R01‐CA89081‐01)
- Canadian Institutes of Health Research (MOP‐15631)
This publication has 34 references indexed in Scilit:
- Parallel cascades: New ways to describe noise transfer in medical imaging systemsMedical Physics, 2001
- Optimization of x‐ray imaging geometry (with specific application to flat‐panel cone‐beam computed tomography)Medical Physics, 2000
- Digital radiology using active matrix readout of amorphous selenium: Construction and evaluation of a prototype real‐time detectorMedical Physics, 1997
- Digital radiology using active matrix readout of amorphous selenium: Theoretical analysis of detective quantum efficiencyMedical Physics, 1997
- Empirical and theoretical investigation of the noise performance of indirect detection, active matrix flat‐panel imagers (AMFPIs) for diagnostic radiologyMedical Physics, 1997
- A spatial‐frequency dependent quantum accounting diagram and detective quantum efficiency model of signal and noise propagation in cascaded imaging systemsMedical Physics, 1994
- Considerations for High Frame Rate Operation of Two-Dimensional a-Si:H Imaging ArraysMRS Proceedings, 1993
- Detective quantum efficiency of imaging systems with amplifying and scattering mechanismsJournal of the Optical Society of America A, 1987
- The noise power spectrum of CT imagesPhysics in Medicine & Biology, 1987
- Practical cone-beam algorithmJournal of the Optical Society of America A, 1984