Rigid body load identification for manipulators
- 1 December 1985
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 24, 996-1002
- https://doi.org/10.1109/cdc.1985.268649
Abstract
A method for estimating the mass, the center of mass, and the moments of inertia of a rigid body load during general manipulator movement is presented. The algorithm is derived from the Newton-Euler equations and incorporates measurements of the force and torque from a wrist force/torque sensor and of the arm kinematics. The identification equations are linear in the desired unknown parameters, which are estimated by least squares. We have implemented this identification procedure on a PUMA 600 robot equipped with an RTI FS-B wrist force/torque sensor, and on the MIT Serial Link Direct Drive Arm equipped with a Barry Wright Company Astek wrist force/torque sensor.Keywords
This publication has 7 references indexed in Scilit:
- Self-calibration in robot manipulatorsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Identification of parameters in models of robots with rotary jointsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Estimation of inertial parameters of rigid body links of manipulatorsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1985
- Adaptation In Biological Sensory-Motor Systems: A Model For Robotic Control.Published by SPIE-Intl Soc Optical Eng ,1985
- Analysis and Design of a Direct-Drive Arm With a Five-Bar-Link Parallel Drive MechanismJournal of Dynamic Systems, Measurement, and Control, 1984
- An Introduction to Robot TechnologyPublished by Springer Nature ,1983
- On-Line Computational Scheme for Mechanical ManipulatorsJournal of Dynamic Systems, Measurement, and Control, 1980