A unified simulation of the filling and postfilling stages in injection molding. Part I: Formulation
- 1 January 1991
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 31 (2) , 116-124
- https://doi.org/10.1002/pen.760310210
Abstract
No abstract availableKeywords
This publication has 37 references indexed in Scilit:
- Flow of polymers with pressure‐dependent viscosity in injection molding diesPolymer Engineering & Science, 1979
- Flow and heat transfer in the nozzle of an injection molding machinePolymer Engineering & Science, 1977
- Injection molding in disk‐shaped cavitiesPolymer Engineering & Science, 1977
- Mold‐filling studies for the injection molding of thermoplastic materials. Part II: The transient flow of plastic materials in the cavities of injection‐molding diesPolymer Engineering & Science, 1975
- Mold‐filling studies for the injection molding of thermoplastic materials. Part I: The flow of plastic materials in hot‐ and cold‐walled circular channelsPolymer Engineering & Science, 1975
- Flow analysis network (FAN)—A method for solving flow problems in polymer processingPolymer Engineering & Science, 1974
- Simulation of the mold‐filling processPolymer Engineering & Science, 1974
- A numerical simulation of the cavity filling process with PVC in injection moldingPolymer Engineering & Science, 1973
- Hele Shaw flows with a free boundary produced by the injection of fluid into a narrow channelJournal of Fluid Mechanics, 1972
- Numerical simulation of injection mold fillingPolymer Engineering & Science, 1970