High performance of high-voltage 4H-SiC Schottky barrier diodes
- 1 June 1995
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 16 (6) , 280-282
- https://doi.org/10.1109/55.790735
Abstract
High performance of high-voltage rectifiers could be realized utilizing 4H-SiC Schottky barrier diodes. A typical specific on-resistance (R/sub on/) of these devices was 1.4/spl times/10/sup 3/ /spl Omega/ cm/sup 3/ at 24/spl deg/C (room temperature) with breakdown voltages as high as 800 V. These devices based on 4H-SiC had R/sub on/'s lower than 6H-SiC based high-power rectifiers with the same breakdown voltage. As for Schottky contact metals, Au, Ni, and Ti were employed in this study. The barrier heights of these metals for 4H-SiC were determined by the analysis of current-voltage characteristics, and the reduction of power loss could be achieved by controlling the barrier heights.Keywords
This publication has 14 references indexed in Scilit:
- 4H-SiC MESFET with 2.8 W/mm power density at 1.8 GHzIEEE Electron Device Letters, 1994
- High-quality 4H-SiC homoepitaxial layers grown by step-controlled epitaxyApplied Physics Letters, 1994
- High frequency performance of SiC heterojunction bipolar transistorsIEEE Transactions on Electron Devices, 1994
- High-voltage (>1 kV) SiC Schottky barrier diodes with low on-resistancesIEEE Electron Device Letters, 1993
- Nitrogen donors in 4H-silicon carbideJournal of Applied Physics, 1993
- Comparison of 6H-SiC, 3C-SiC, and Si for power devicesIEEE Transactions on Electron Devices, 1993
- Influence of surface energy on the growth of 6H- and 4H-SiC polytypes by sublimationMaterials Science and Engineering: B, 1992
- Power semiconductor device figure of merit for high-frequency applicationsIEEE Electron Device Letters, 1989
- Group IV materials (mainly SiC)Published by Springer Nature ,1977
- Electron Mobility Measurements in SiC PolytypesJournal of Applied Physics, 1967