Mechanics of Orthogonal Machining: Predicting Chip Geometry and Cutting Forces from Work-Material Properties and Cutting Conditions
- 1 June 1969
- journal article
- other
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers
- Vol. 184 (1) , 927-942
- https://doi.org/10.1243/pime_proc_1969_184_068_02
Abstract
A recently developed theory of orthogonal machining is used to calculate chip geometry (including tool-chip contact length) and cutting forces for SAE 1112 steel over a wide range of cutting conditions. A comparison with experimental results shows excellent agreement for most of the cutting conditions considered.Keywords
This publication has 10 references indexed in Scilit:
- The temperature and strain-rate dependence of the shear strength of mild steelPhilosophical Magazine, 1970
- An Experimental Investigation of the Influence of Speed and Scale on the Strain-Rate in a Zone of Intense Plastic DeformationProceedings of the Institution of Mechanical Engineers, 1969
- Resistance to dynamic compression of low-carbon steel and alloy steels at elevated temperatures and at high strain-ratesInternational Journal of Mechanical Sciences, 1968
- Mechanics of Orthogonal Machining: Allowing for the Effects of Strain Rate and Temperature on Tool-Chip FrictionProceedings of the Institution of Mechanical Engineers, 1968
- An analysis of the plastic deformation due to orthogonal and oblique cuttingJournal of Strain Analysis, 1966
- Flow along Tool-Chip Interface in Orthogonal Metal CuttingJournal of Mechanical Engineering Science, 1966
- Shear-Plane Temperature Distribution in Orthogonal CuttingTransactions of the American Society of Mechanical Engineers, 1955
- A theoretical investigation of the temperature distribution in the metal cutting processBritish Journal of Applied Physics, 1954
- Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 ChipJournal of Applied Physics, 1945
- Influence of Rate of Strain and Temperature on Yield Stresses of Mild SteelJournal of Applied Mechanics, 1944