Electrostatic control of microstructure thermal conductivity
- 19 March 2001
- journal article
- Published by AIP Publishing in Applied Physics Letters
- Vol. 78 (12) , 1778-1780
- https://doi.org/10.1063/1.1355302
Abstract
A technology for controlling the thermal conductivity of etch-released microstructures is proposed and demonstrated by placing test structures in and out of contact with their underlying substrate. By adjusting the duty cycle of a periodic actuation, the thermal conductivity can be adjusted linearly across a wide range. Experimental work with microfilaments in air has shown a continuous tuning range from approximately 1.7×10−4 W/K to 3.3×10−4 W/K. These numbers are limited by thermal conduction through air and thermal contact conductance, respectively. The fundamental tuning range is orders of magnitude wider, limited by radiation heat transfer and the thermal contact conductance of coated structures.Keywords
This publication has 9 references indexed in Scilit:
- High aspect-ratio combined poly and single-crystal silicon (HARPSS) MEMS technologyJournal of Microelectromechanical Systems, 2000
- Micro total analysis system (?TAS)Electronics and Communications in Japan (Part II: Electronics), 1999
- Average power control and positioning of polysilicon thermal actuatorsSensors and Actuators A: Physical, 1999
- Prediction of thermal contact resistance between polished surfacesInternational Journal of Heat and Mass Transfer, 1998
- Monolithic two-dimensional arrays of micromachined microstructures for infrared applicationsProceedings of the IEEE, 1998
- A mechanical and geometrical approach to thermal contact resistanceInternational Journal of Heat and Mass Transfer, 1997
- Thermal characterization of surface-micromachined silicon nitride membranes for thermal infrared detectorsJournal of Microelectromechanical Systems, 1997
- Thermomechanical characteristics of a thermal switchSensors and Actuators A: Physical, 1996
- Microfabricated incandescent lampsApplied Optics, 1991