The surface/bulk micromachining (SBM) process: a new method for fabricating released MEMS in single crystal silicon
- 1 December 1999
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 8 (4) , 409-416
- https://doi.org/10.1109/84.809055
Abstract
This paper presents the surface/bulk micromachining (SBM) process to allow fabricating released microelectromechanical systems using bulk silicon. The process starts with a [111]-oriented silicon wafer. The structural patterns are defined using the reactive ion etching technique used in surface micromachining. Then the patterns, as well as sidewalls, are passivated with an oxide film, and bare silicon is exposed at desired areas. The exposed bare silicon is further reactive ion etched, which defines sacrificial gap dimensions. The final release is accomplished by undercutting the exposed bulk silicon sidewalls in aqueous alkaline etchants. Because {111} planes are used as etch stops, very clean structural surfaces can be obtained. Using the SBM process, 5-, 10-, and 100-/spl mu/m-thick arbitrarily-shaped single crystal silicon structures, including comb-drive resonators, at 5-, 30-, and 100-/spl mu/m sacrificial gaps, respectively, are fabricated. An electrostatic actuation method using p-n junction isolation is also developed in this paper, and it is applied to actuate comb-drive resonators. The leakage current and junction capacitance of the reversed-biased p-n junction diodes are also found to be sufficiently small for sensor applications. The developed SBM process is a plausible alternative to the existing micromachining methods in fabricating microsensors and microactuators, with the advantage of using single crystal silicon.Keywords
This publication has 18 references indexed in Scilit:
- The Black Silicon Method V: A Study Of The Fabricating Of Movable Structures For Micro Electromechanical SystemsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Fabrication of a single crystalline silicon capacitive lateral accelerometer using micromachining based on single step plasma etchingPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- A New Micromachining Technique with (111) SiliconJapanese Journal of Applied Physics, 1999
- Porous silicon as a sacrificial materialJournal of Micromechanics and Microengineering, 1996
- Batch-dissolved wafer process for low-cost sensor applicationsPublished by SPIE-Intl Soc Optical Eng ,1995
- Free standing single-crystal silicon microstructuresJournal of Micromechanics and Microengineering, 1995
- A latching accelerometer fabricated by the anisotropic etching of (110) oriented silicon wafersJournal of Micromechanics and Microengineering, 1992
- Confined lateral selective epitaxial growth of silicon for device fabricationIEEE Electron Device Letters, 1990
- Electrostatic-comb drive of lateral polysilicon resonatorsSensors and Actuators A: Physical, 1990
- Use of Modified Free Energy Theorems to Predict Equilibrium Growing and Etching ShapesJournal of Applied Physics, 1962