TX and RX Front-Ends for 60GHz Band in 90nm Standard Bulk CMOS
- 1 February 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE International Solid-State Circuits Conference
- No. 01936530,p. 558-635
- https://doi.org/10.1109/isscc.2008.4523305
Abstract
This paper describes the design of a mm-wave power amplifier PA with reliability considerations for hot carrier injection (HCI) degradation. A 60GHz-band single-chip transmitter front- end with an output power of 6dBm for 2.6 Gb/s QPSK modulation and a single-chip receiver front-end are implemented in a standard IV 90 nm CMOS technology.Keywords
This publication has 7 references indexed in Scilit:
- A 60-GHz CMOS Receiver with Frequency SynthesizerPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2007
- Algorithmic Design of CMOS LNAs and PAs for 60-GHz RadioIEEE Journal of Solid-State Circuits, 2007
- Low-Power mm-Wave Components up to 104GHz in 90nm CMOSIEEE International Solid-State Circuits Conference, 2007
- A 60GHz Low-Power Six-Port Transceiver for Gigabit Software-Defined Transceiver ApplicationsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2007
- A Highly Integrated 60GHz CMOS Front-End ReceiverPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2007
- Hot carrier effect on CMOS RF amplifiersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Consideration of age degradation in the RF performance of CMOS radio chips for high volume manufacturingPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005