Guidelines for etching silicon MEMS structures using fluorine high-density plasmas at cryogenic temperatures
Top Cited Papers
- 7 November 2002
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 11 (4) , 385-401
- https://doi.org/10.1109/jmems.2002.800928
Abstract
This paper presents guidelines for the deep reactive ion etching (DRIE) of silicon MEMS structures, employing SF/sub 6//O/sub 2/-based high-density plasmas at cryogenic temperatures. Procedures of how to tune the equipment for optimal results with respect to etch rate and profile control are described. Profile control is a delicate balance between the respective etching and deposition rates of a SiO/sub x/F/sub y/ passivation layer on the sidewalls and bottom of an etched structure in relation to the silicon removal rate from unpassivated areas. Any parameter that affects the relative rates of these processes has an effect on profile control. The deposition of the SiO/sub x/F/sub y/ layer is mainly determined by the oxygen content in the SF/sub 6/ gas flow and the electrode temperature. Removal of the SiO/sub x/F/sub y/ layer is mainly determined by the kinetic energy (self-bias) of ions in the SF/sub 6//O/sub 2/ plasma. Diagrams for profile control are given as a function of parameter settings, employing the previously published "black silicon method". Parameter settings for high rate silicon bulk etching, and the etching of micro needles and micro moulds are discussed, which demonstrate the usefulness of the diagrams for optimal design of etched features. Furthermore, it is demonstrated that in order to use the oxygen flow as a control parameter for cryogenic DRIE, it is necessary to avoid or at least restrict the presence of fused silica as a dome material, because this material may release oxygen due to corrosion during operation of the plasma source. When inert dome materials like alumina are used, etching recipes can be defined for a broad variety of microstructures in the cryogenic temperature regime. Recipes with relatively low oxygen content (1-10% of the total gas volume) and ions with low kinetic energy can now be applied to observe a low lateral etch rate beneath the mask, and a high selectivity (more than 500) of silicon etching with respect to polymers and oxide mask materials is obtained. Crystallographic preference etching of silicon is observed at low wafer temperature (-120/spl deg/C). This effect is enhanced by increasing the process pressure above 10 mtorr or for low ion energies (below 20 eV).Keywords
This publication has 26 references indexed in Scilit:
- The black silicon method. VIII. A study of the performance of etching silicon using SF6/O2-based chemistry with cryogenical wafer cooling and a high density ICP sourceMicroelectronics Journal, 2001
- Thin photodiodes for a neutron scintillator silicon-well detectorIEEE Transactions on Nuclear Science, 2001
- Simulation of anisotropic wet chemical etching using a physical modelSensors and Actuators A: Physical, 2000
- BSM 7: RIE lag in high aspect ratio trench etching of siliconMicroelectronic Engineering, 1997
- Ion-assisted Si/XeF2 etching: Temperature dependence in the range 100–1000 KJournal of Vacuum Science & Technology A, 1996
- Comparison of advanced plasma sources for etching applications. V. Polysilicon etching rate, uniformity, profile control, and bulk plasma properties in a helical resonator plasma sourceJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures, 1996
- The black silicon method: a universal method for determining the parameter setting of a fluorine-based reactive ion etcher in deep silicon trench etching with profile controlJournal of Micromechanics and Microengineering, 1995
- The black silicon method. VI. High aspect ratio trench etching for MEMS applicationsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1995
- On the Mechanism of Anisotropic Etching of SiliconJournal of the Electrochemical Society, 1993
- Angular ion and neutral energy distribution in a collisional rf sheathJournal of Applied Physics, 1991