Code construction and FPGA implementation of a low-error-floor multi-rate low-density Parity-check code decoder

Abstract
With the superior error correction capability, low-density parity-check (LDPC) codes have initiated wide scale interests in satellite communication, wireless communication, and storage fields. In the past, various structures of single code-rate LDPC decoders have been reported. However, to cover a wide range of service requirements and diverse interference conditions in wireless applications, LDPC decoders that can operate at both high and low code rates are desirable. In this paper, a 9-k code length multi-rate LDPC decoder architecture is presented and implemented on a Xilinx field-programmable gate array device. Using pin selection, three operating modes, namely, the irregular 1/2 code mode, the regular 5/8 code mode, and the regular 7/8 code mode, are supported. Furthermore, to suppress the error floor level, a characterization on the conditions for short cycles in a LDPC code matrix expanded from a small base matrix is presented, and a cycle elimination algorithm is developed to detect and break such short cycles. The effectiveness of the cycle elimination algorithm has been verified by both simulation and hardware measurements, which show that the error floor is suppressed to a much lower level without incurring any performance penalty. The implemented decoder is tested in an experimental LDPC orthogonal frequency division multiplexing system and achieves the superior measured performance of block error rate below 10/sup -7/ at signal-to-noise ratio of 1.8 dB.

This publication has 17 references indexed in Scilit: