Pulsed electron-beam annealing of selenium-implanted gallium arsenide
- 1 October 1979
- journal article
- Published by AIP Publishing in Applied Physics Letters
- Vol. 35 (7) , 546-548
- https://doi.org/10.1063/1.91210
Abstract
Electrical properties of selenium‐implanted gallium arsenide annealed by a single shot of high‐power pulsed electron beams have been investigated by differential Hall‐effect and sheet‐resistivity measurements. It has been shown that higher electrical activation of implanted selenium can be obtained after electron‐beam annealing at an incident energy density of 1.2 J/cm2, independent of heating of GaAs substrate during implantation. Measured carrier concentrations exhibit uniformly distributed profiles having carrier concentrations of 2–3×1019/cm3, which is difficult to realize by conventional thermal annealing.Keywords
This publication has 11 references indexed in Scilit:
- A melting model for pulsing-laser annealing of implanted semiconductorsJournal of Applied Physics, 1979
- Electrical properties of laser-annealed donor-implanted GaAsElectronics Letters, 1978
- Chemical Vapor Deposition of Silicon Nitride: Encapsulant Layers for Annealing Gallium ArsenideJournal of the Electrochemical Society, 1978
- p-n junction formation in boron-deposited silicon by laser-induced diffusionApplied Physics Letters, 1978
- Annealing of Se-implanted GaAs with an oxygen-free CVD Si3N4 encapsulantJournal of Applied Physics, 1978
- Laser reordering of implanted amorphous layers in GaAsSolid-State Electronics, 1978
- Laser annealing of boron-implanted siliconApplied Physics Letters, 1978
- Study of Encapsulants for Annealing GaAsJournal of the Electrochemical Society, 1977
- Silicon solar cells by high-speed low-temperature processingIEEE Transactions on Electron Devices, 1977
- Selenium implantation in GaAsSolid-State Electronics, 1977