Annealing of selenium-implanted GaAs
- 15 December 1984
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 56 (12) , 3503-3507
- https://doi.org/10.1063/1.333916
Abstract
The electrical and structural properties of 1×1014 Se+ cm−2, 100–400 kV and 5×1012 Se++ cm−2, 350‐kV implants into (100) semi‐insulating GaAs have been studied. Peak carrier concentrations of 5×1018 cm−3 have been measured and mobilities >4000 cm2 V−1 s−1 obtained for low‐dose implants (n=1–2×1017 cm−3) by annealing samples on a graphite strip heater. Si3N4 and AlN have been used as encapsulants. Comparisons are made with capless annealing in an arsine ambient.This publication has 31 references indexed in Scilit:
- Shallow ion implantation in gallium arsenideVacuum, 1984
- Formation of Gallium Nitride at the Interface between Silicon Nitride Encapsulant and Ion Implanted GaAsJapanese Journal of Applied Physics, 1983
- Capless annealing of silicon implanted gallium arsenideSolid-State Electronics, 1983
- Application of thermal pulse annealing to ion-implanted GaAlAs/GaAs heterojunction bipolar transistorsIEEE Electron Device Letters, 1983
- Thin film encapsulants for annealing GaAs and InPThin Solid Films, 1983
- Redistribution of manganese after annealing of GaAs implanted with Si+ and Se+Applied Physics Letters, 1982
- Transient annealing of selenium-implanted gallium arsenide using a graphite strip heaterApplied Physics Letters, 1982
- Stoichiometric disturbances in ion implanted GaAs and redistribution of Cr during annealingApplied Physics Letters, 1981
- A double-layered encapsulant for annealing ion-implanted GaAs up to 1100 °CApplied Physics Letters, 1977
- The evaporation of GaAs under equilibrium and non-equilibrium conditions using a modulated beam techniqueJournal of Physics and Chemistry of Solids, 1973