Fabrication of 300-Å metal lines with substrate-step techniques
- 1 July 1980
- journal article
- research article
- Published by AIP Publishing in Applied Physics Letters
- Vol. 37 (1) , 94-96
- https://doi.org/10.1063/1.91716
Abstract
Metal lines as narrow as 30 nm and as long as 0.5 mm have been fabricated by new techniques based on substrates with surface‐relief steps. Substrate steps with a square profile are formed by ion‐beam etching. Metal wires of triangular cross section are produced by ion‐etching a metal‐coated substrate at an angle, so that the wire is formed in the shadow of the step. An alternative process, direct evaporation onto the step edge, is used to produce lines of very high aspect ratio of height to width.Keywords
This publication has 14 references indexed in Scilit:
- 400-Å linewidth e-beam lithography on thick silicon substratesApplied Physics Letters, 1980
- Step-edge fabrication of ultrasmall Josephson microbridgesApplied Physics Letters, 1980
- Replication of 175-Å lines and spaces in polymethylmethacrylate using x-ray lithographyApplied Physics Letters, 1980
- X-ray lithography at ∠100 Å linewidths using x-ray masks fabricated by shadowing techniquesJournal of Vacuum Science and Technology, 1979
- Experimental Study of Anderson Localization in Thin WiresPhysical Review Letters, 1979
- A simple method for fabricating lines of 0.15-μ width using optical lithographyApplied Physics Letters, 1979
- 250-Å linewidths with PMMA electron resistApplied Physics Letters, 1978
- Electron-beam fabrication of 80-Å metal structuresApplied Physics Letters, 1976
- Argon ion etching in a reactive gasJournal of Materials Science, 1973
- A High-Yield Photolithographic Technique for Surface Wave DevicesJournal of the Electrochemical Society, 1971