Direct Method of Measuring the Contact Injection Ratio
- 1 October 1956
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 27 (10) , 828-829
- https://doi.org/10.1063/1.1715386
Abstract
A direct method of measuring the injection ratio of rectifying contacts is described. With this method, the injection ratio is determined by comparing the area of a current injection pulse with the area of the resulting hole storage pulse as observed on an oscilloscope screen.Keywords
This publication has 15 references indexed in Scilit:
- Minority Carrier Extraction in GermaniumPhysical Review B, 1955
- A Pulse Method for Measuring the Injection Ratio of Metal-Semiconductor ContactsProceedings of the Physical Society. Section B, 1955
- Transient Response of a p-n JunctionJournal of Applied Physics, 1954
- Charge Storage in Junction DiodesJournal of Applied Physics, 1954
- Measurement of Minority Carrier Lifetime and Contact Injection Ratio on Transistor MaterialsProceedings of the Physical Society. Section B, 1954
- Recovery Currents in Germanium p — n Junction DiodesJournal of Applied Physics, 1953
- Post-Injection Barrier Electromotive Force ofJunctionsPhysical Review B, 1953
- Recombination Rate in Germanium by Observation of Pulsed Reverse CharacteristicPhysical Review B, 1953
- On Some Transients in the Pulse Response of Point-Contact Germanium DiodesProceedings of the IRE, 1952
- Hole Injection in Germanium-Quantitative Studies and Filamentary Transistors*Bell System Technical Journal, 1949