Design and fabrication of an angular microactuator for magnetic disk drives
- 1 June 1998
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 7 (2) , 141-148
- https://doi.org/10.1109/84.679333
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Transverse mode electrostatic microactuator for MEMS-based HDD sliderPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- An electrostatic micro actuator for a magnetic head tracking system of hard disk drivesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Batch transfer of microstructures using flip-chip solder bump bondingPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Micro-actuators for high density disk drivesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1997
- Measurements of Young's modulus, Poisson's ratio, and tensile strength of polysiliconPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1997
- Future trends in hard disk drivesIEEE Transactions on Magnetics, 1996
- Microactuator control for disk driveIEEE Transactions on Magnetics, 1996
- Design, fabrication, position sensing, and control of an electrostatically-driven polysilicon microactuatorIEEE Transactions on Magnetics, 1996
- Magnetic recording-head positioning at very high track densities using a microactuator-based, two-stage servo systemIEEE Transactions on Industrial Electronics, 1995
- Spin-valve RAM cellIEEE Transactions on Magnetics, 1995