Analyzing multichip module testing strategies
- 1 January 1994
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Design & Test of Computers
- Vol. 11 (1) , 40-52
- https://doi.org/10.1109/54.262321
Abstract
Incorporating test and fault diagnosis as critical design requirements is necessary to achieve high-quality, cost-effective multichip systems. However, evaluating where and when to test, and deciding upon the best test method and level, take considerable study. The authors explore the trade-offs between various MCM test and rework strategies, then analyze the impact of cost, yield, and test effectiveness of the final cost and quality. This analysis of the trade-offs associated with test strategies for complex multichip systems and modules clearly indicate that incorporating DFT and BIST with varying degrees at the chip or MCM levels is economically justifiable. These methods result in cost reduction as well as quality improvement, and indicate that the MCM cost could vary by about 10% to 20%, depending on the test strategy used. However, proper determination of where and how to test, and whether to employ DFT and BIST at the IC or MCM levels, require an evaluation of the economics of the various solutions and the payback. This process is highly dependent on the design under consideration and the parameters associated with the available manufacturing environments.Keywords
This publication has 8 references indexed in Scilit:
- HIGH-DENSITY CMOS MULTICHIP-MODULE TESTING AND DIAGNOSISPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- Computer aided conceptual design of multichip systemsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Bare chip test techniques for multichip modulesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- High-yield assembly of multichip modules through known-good IC's and effective test strategiesProceedings of the IEEE, 1992
- Board test DFT model for computer productsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1992
- Quality Level and Fault Coverage for Multichip ModulesPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1983
- Fault coverage requirement in production testing of LSI circuitsIEEE Journal of Solid-State Circuits, 1982
- Defect Level as a Function of Fault CoverageIEEE Transactions on Computers, 1981