M-TEST: A test chip for MEMS material property measurement using electrostatically actuated test structures
- 1 June 1997
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 6 (2) , 107-118
- https://doi.org/10.1109/84.585788
Abstract
A set of electrostatically actuated microelectromechanical test structures is presented that meets the emerging need for microelectromechanical systems (MEMS) process monitoring and material property measurement at the wafer level during both process development and manufacturing. When implemented as a test chip or drop-in pattern for MEMS processes, M-Test becomes analogous to the electrical MOSFET test structures (often called E-Test) used for extraction of MOS device parameters. The principle of M-Test is the electrostatic pull-in of three sets of test structures [cantilever beams (CB's), fixed-fixed beams (FB's), and clamped circular diaphragms (CD's)] followed by the extraction of two intermediate quantities (the S and B parameters) that depend on the product of material properties and test structure geometry. The S and B parameters give a direct measure of the process uniformity across an individual wafer and process repeatability between wafers and lots. The extraction of material properties (e.g., Young's modulus, plate modulus, and residual stress) from these S and B parameters is then accomplished using geometric metrology data. Experimental demonstration of M-Test is presented using results from MIT's dielectrically isolated wafer-bonded silicon process. This yielded silicon plate modulus results which agreed with literature values to within /spl plusmn/4%. Guidelines for adapting the method to other MEMS process technologies are presented.Keywords
This publication has 10 references indexed in Scilit:
- Monitoring plasma over-etching of Wafer-bonded MicrostructuresPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2005
- A novel technique and structure for the measurement of intrinsic stress and Young's modulus of thin filmsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Calibrated measurements of elastic limit, modulus, and the residual stress of thin films using micromachined suspended structuresPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Implementation of MEMCAD system for electrostatic and mechanical analysis of complex structures from mask descriptionsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- 3D coupled electro-mechanics for MEMS: applications of CoSolve-EMPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1995
- Mechanical Characterization of Thin Films by Micromechanical TechniquesMRS Bulletin, 1992
- Electronic Determination of the Modulus of Elasticity and Intrinsic Stress of Thin Films using Capacitive BridgesMRS Proceedings, 1992
- Microfabricated structures for the i n s i t u measurement of residual stress, Young’s modulus, and ultimate strain of thin filmsApplied Physics Letters, 1987
- Dynamic micromechanics on silicon: Techniques and devicesIEEE Transactions on Electron Devices, 1978
- Calculated elastic constants for stress problems associated with semiconductor devicesJournal of Applied Physics, 1973