Measurements of Dose to Failure versus Dose Rate for CMOS/NMOS Static RAMS
- 1 January 1986
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 33 (6) , 1697-1701
- https://doi.org/10.1109/TNS.1986.4334667
Abstract
4K×4 CMOS/NMOS static RAMS have been tested to failure at 23, 70, 270 and 1,560 rad (Si) hour. Catastrophic failure was observed to occur at relatively small dose increments after parametric failure. The relation between failure dose and dose rate has been examined by the application of linear system theory.Keywords
This publication has 12 references indexed in Scilit:
- Correlation of Radiation Effects in Transistors and Integrated CircuitsIEEE Transactions on Nuclear Science, 1985
- Estimating Electronic Parameter End Points for Devices Which Suffer Abrupt Functional Failure during Radiation TestingIEEE Transactions on Nuclear Science, 1985
- A Comparison of Conventional Dose Rate and Low Dose Rate Co-60 Testing of Idt Static RAMS and FSC MultiplexersIEEE Transactions on Nuclear Science, 1985
- A Comparison of Conventional 60Co Testing and Low Dose-Accumulation-Rate Exposure of Metal-Gate CMOS IC'sIEEE Transactions on Nuclear Science, 1984
- Dose Rate Effects in MOS MicrocircuitsIEEE Transactions on Nuclear Science, 1984
- Modeling of MOS Radiation and Post Irradiation EffectsIEEE Transactions on Nuclear Science, 1984
- Physical Mechanisms Contributing to Device "Rebound"IEEE Transactions on Nuclear Science, 1984
- Super Recovery of Total Dose Damage in MOS DevicesIEEE Transactions on Nuclear Science, 1984
- Recovery of Damage in Rad-Hard MOS Devices during and after Irradiation by Electrons, Protons, Alphas, and Gamma RaysIEEE Transactions on Nuclear Science, 1983
- Predicting CMOS Inverter Response in Nuclear and Space EnvironmentsIEEE Transactions on Nuclear Science, 1983